[AusNOG] NBN NCAS on Cisco 867VAE-K9

[Jarryd Sullivan]

Can confirm that the 867VAE-K9 in any form will not work, only the later wireless model that was released had the ability to have the VDSL controller firmware updated which supported vectoring. The non-wireless models are basically pointless now. We’ve moved to C887VA’s for all our small deployments where the 867 used to fit.

Jarryd Sullivan


From: AusNOG <ausnog-bounces at lists.ausnog.net> On Behalf Of Pouya Madani
Sent: Tuesday, 9 April 2019 11:58 AM
To: ausnog at lists.ausnog.net
Subject: [AusNOG] NBN NCAS on Cisco 867VAE-K9

Hi,

Has anyone had any luck with configuring a Cisco 867VAE-K9 (not the 867VAE-W) on NBN NCAS? [VDSL handoff, and Vlan tag 100 on WAN (via AAPT)]

I have almost tried any recommendations on AusNog, Whirpool, Cisco and many other Communities with no luck. I understand 867VAE chipset is different to 867VAE-W, and that 867VAE-W works just fine on NBN NCAS, but the 867VAE-K9 has not worked for me yet.

Has anyone got an 867VAE-K9 working on NCAS by any chance, and if so can I have a copy of the vdsl controller and ethernet0.100 config please?

Kind Regards,
Pedro Madani

________________________________

The information contained in this message and any attachments may be confidential information. If you are not the intended recipient, you must not use or forward the information contained in these documents. If you have received this message in error, please delete the email and notify the sender.

Internet communications are not secure. You should scan this message and any attachments for viruses. Under no circumstances do we accept liability for any loss or damage which may result from your receipt of this message or any attachments.