[AusNOG] First provisioning on FTTN

[Damien Gardner Jnr]

Have you set the correct vlan tag and priority in the Modem settings?  This
has been the key on the couple of PPPoE FTTN connections I've setup..

On Friday, 27 May 2016, Cameron Murray <cameron.murray at gmail.com> wrote:

> Evening Noggers,
>
> We today we've provisioned our first FTTN service and everything is
> looking good, 107mbps/44mbps sync on the modem however there is one fatal
> floor.... It will not Auth
>
> Is there any secrets to this? We are using the NetComm NF8AC which is on
> the registered NBN list however so far no success.
>
> Found the following on the pool of winge however no luck with the stated
> settings: https://forums.whirlpool.net.au/archive/2523433
>
> Any advice or assistance would be greatly appreciated. Have another 5 FTTN
> to activate in the next week so need a working config before dispatch of
> hardware.
>
> Cheers
>
> Cameron
>


-- 

Damien Gardner Jnr
VK2TDG. Dip EE. GradIEAust
rendrag at rendrag.net -  http://www.rendrag.net/
--
We rode on the winds of the rising storm,
 We ran to the sounds of thunder.
We danced among the lightning bolts,
 and tore the world asunder
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.ausnog.net/pipermail/ausnog/attachments/20160527/729ce145/attachment.html>