[AusNOG] Internode IPv6 Support

[Nick Edwards]

stop thread?

this is not internodes support forum, nor is freakin whingepool

the mods used to jump in real quick when the list degraded into end
user support, are they all on holidays?


On 10/20/15, Mark Newton <newton at atdot.dotat.org> wrote:
> On Oct 19, 2015, at 3:01 PM, Karl Auer <kauer at biplane.com.au> wrote:
>> On Mon, 2015-10-19 at 13:36 +1000, David Beveridge wrote:
>>>> • Acquire a dynamic /64 prefix with NDP Router Solicitation (RFC 4861)
>>> Note sure about this one, no IPv6 Address is appearing
>>
>> I don't get a prefix on the outside interface. There is no technical
>> need for one, either, the link is point to point so the link local
>> addresses are all that's needed.
>
> The point was to make sure that a user with a single PC plugged into the
> ethernet jack on their bridged-mode CPE would have a working internet
> service.
>
>
>   - mark
>
>
> _______________________________________________
> AusNOG mailing list
> AusNOG at lists.ausnog.net
> http://lists.ausnog.net/mailman/listinfo/ausnog
>