[AusNOG] 10Gb Switching - Cheap but good

[Dan]

I checked the MT site and 6.29 firmware shows a fix for 10gbe dropouts. Not sure if that's the same issue your seeing 


> On 31 May 2015, at 10:27 am, Skeeve Stevens <skeeve+ausnog at theispguy.com> wrote:
> 
> I don't have performance issues. I have interfaces randomly dropping and staying down until you shut/no shut equiv to them.
> 
> And I have a MT guy who is at a loss to explain why they are doing it.
> 
> 
> ...Skeeve
> 
> --
> Skeeve Stevens - The ISP Guy - Internet Provider SME
> Email: skeeve at theispguy.com ; Cell: +61(0)414 753 383
> Skype: skeeve; Blog: TheISPGuy.com ; Facebook: TheISPGuy
> Linkedin: /in/skeeve ; Expert360: Profile
> 
>> On Sat, May 30, 2015 at 11:57 PM, Mike Everest <mike at duxtel.com> wrote:
>> Not at all!
>> 
>>  
>> 
>> Diagnostic toolset built in to routerOS is actually quite good :-)
>> 
>>  
>> 
>> It is definitely worth running an eye over your config just to make sure you aren’t inadvertently pushing packets through CPU – that is a surefire way to end up with crap performance ;)
>> 
>> 
>> Get in touch with support at duxtel.com if you’d like to find out if your cloud router switch can give you a better experience.
>> 
>> 
>> Cheers!
>> 
>>  
>> 
>> Mike.
>> 
>>  
>> 
>> From: Skeeve Stevens [mailto:skeeve+ausnog at eintellegonetworks.com] 
>> Sent: Saturday, 30 May 2015 12:43 PM
>> To: Mike Everest
>> Cc: <ausnog at lists.ausnog.net>
>> Subject: Re: [AusNOG] 10Gb Switching - Cheap but good
>> 
>>  
>> 
>> Diagnostics on this model seem to be hard to get.  We've got a fibre link to another enterprise switch that just seems to go down randomly... across 6 different units so far with different connectivity scenarios.
>> 
>> 
>> 
>> 
>> ...Skeeve
>> 
>>  
>> 
>> Skeeve Stevens - Founder & Chief Network Architect 
>> 
>> eintellego Networks Pty Ltd
>> 
>> Email: skeeve at eintellegonetworks.com
>> 
>> Cell +61 (0)414 753 383 ; Skype: skeeve
>> LinkedIn: /in/skeeve ; Expert360: Profile
>>  
>> 
>>  
>> 
>> On Sat, May 30, 2015 at 11:44 AM, Mike Everest <mike at duxtel.com> wrote:
>> 
>> Hey Skeeve!
>> 
>>  
>> 
>> Did you try any diagnostics or get support feedback on that?  I’ve seen that switch hardware work quite well when using hardware alone :-}
>> 
>>  
>> 
>> If you’d like to contact our support guys off list (support at duxtel.com) I’ll be very keen to try to repro that observed behaviour then see what we can do to find some resolution :-)
>> 
>>  
>> 
>> Cheers! Mike.
>> 
>>  
>> 
>> From: AusNOG [mailto:ausnog-bounces at lists.ausnog.net] On Behalf Of Skeeve Stevens
>> Sent: Friday, 29 May 2015 12:24 AM
>> To: <ausnog at lists.ausnog.net>
>> Subject: [AusNOG] 10Gb Switching - Cheap but good
>> 
>>  
>> 
>> Hey all,
>> 
>>  
>> 
>> Was doing some lab testing and needed some cheap 10Gb SFP+ ports - so used the Mikrotik CRS210-8G-2S+IN.
>> 
>>  
>> 
>> What a piece of junk. The OS isn't too bad but the switch hardware can't even keep its 10Gb ports up for very long without dying with little errors. What do you expect for $300 right?
>> 
>>  
>> 
>> So, I am looking for a stable 10Gb (SFP+) solution... 2 ports, preferably 4 SFP+, with a stable OS that can move VLANs around simply with trunks and VLAN access supported. I don't need much super fancy, but a 1RU form factor with rack mounting would be nice. A selection of 1Gb copper ports obviously. Remote ssh (or telnet if I have to) would be appreciated - not GUI please.
>> 
>>  
>> 
>> I think 1k-ish would be reasonable... I don't need Cisco or Juniper... 
>> 
>>  
>> 
>> Recommendations?
>> 
>> 
>> ...Skeeve
>> 
>>  
>> 
>> Skeeve Stevens - Founder & Chief Network Architect 
>> 
>> eintellego Networks Pty Ltd
>> 
>> Email: skeeve at eintellegonetworks.com
>> 
>> Cell +61 (0)414 753 383 ; Skype: skeeve
>> LinkedIn: /in/skeeve ; Expert360: Profile
>>  
>> 
>>  
>> 
>> 
>> _______________________________________________
>> AusNOG mailing list
>> AusNOG at lists.ausnog.net
>> http://lists.ausnog.net/mailman/listinfo/ausnog
> 
> _______________________________________________
> AusNOG mailing list
> AusNOG at lists.ausnog.net
> http://lists.ausnog.net/mailman/listinfo/ausnog
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://lists.ausnog.net/pipermail/ausnog/attachments/20150531/d7a7d838/attachment.html>