[AusNOG] EdgeRouter IPv6 on AussieBB

[Mark Prior]

I don't know if it applies to the EdgeRouter but I had to disable rapid 
commit on my Junos system.

Mark.

On 8/9/19 13:42, Alex Wakefield wrote:
> Hi,
> 
> Does anyone have a working IPv6 setup for an EdgeRouter using the AussieBB beta? I'm using an EdgeRouter Lite running v2.0.6.
> 
> My internal interface manages to get IPs out of the range handed out by Aussie but clients never get an address after that. I'm trying to use SLAAC to hand out IPs. Relevant config on my internet facing port below.
> 
> ethernet eth0 {
>      address dhcp
>      description AussieBB
>      dhcpv6-pd {
>          pd 1 {
>              interface eth2.20 {
>                  host-address ::1
>                  no-dns
>                  prefix-id 0
>                  service slaac
>              }
>              prefix-length 56
>          }
>          rapid-commit enable
>      }
>      duplex auto
>      firewall {
>          in {
>              ipv6-name AussieIn
>              name AussieIn
>          }
>          local {
>              ipv6-name AussieLocal
>              name AussieLocal
>          }
>          out {
>              ipv6-name AussieOut
>              name AussieOut
>          }
>      }
>      ipv6 {
>          address {
>              autoconf
>          }
>      }
>      speed auto
> }
> 
> Regards,
> Alex
> _______________________________________________
> AusNOG mailing list
> AusNOG at lists.ausnog.net
> http://lists.ausnog.net/mailman/listinfo/ausnog
>