[AusNOG] 10G CPE (1RU?) recommendations?

[Mark ZZZ Smith]

>________________________________
> From: jason andrade <jason at pobox.com>
>To: ausnog at lists.ausnog.net 
>Sent: Monday, 12 August 2013 1:16 PM
>Subject: [AusNOG] 10G CPE (1RU?) recommendations?
> 
>
>
>G'day Ausnoggers,
>
>Apologies if you see this twice - i had tried to send it out on Friday but haven't seen it come through.
>
>Can you provide input or a recommendation for a 10Gbps CPE ?
>
>The current CPE is a Cisco ME3400 which is used to deliver 1Gbps access.  There might be a reason to standardise the 10G and 1G platform onto the same type of device in the future.
>
>The base requirements are:
>
>- Layer2/3
>- Support OSPF and BGP for IP Routing
>- SNMP support
>- ACLs
>

http://i.imgur.com/Qfpkxat.png


>The expectation for the 10G CPE is to support throughput of > 1G (but not necessarily full line rate at 10G).
>
>A large number of 10G ports is not necessarily a requirement (or a bonus..) - anywhere from 2 or 4 ports would be more than sufficient.
>
>Also the ability to deal with lots of sessions is more important than  high throughput (above 1Gbit..)
>
>Happy to summarize the results - I've already searched through the previous (Ausnog) CPE thread and the usual places like whirlpool in case there was anything relevant there..
>
>regards,
>
>-jason
>_______________________________________________
>AusNOG mailing list
>AusNOG at lists.ausnog.net
>http://lists.ausnog.net/mailman/listinfo/ausnog
>
>
>