[AusNOG] SSH access into 7204vxr / npe-g1

[Skeeve Stevens]

Hey,

You need to enable SSH for a start.  If you support v2 on your IOS (you should on a g1) you need to set the version.

You need to generate a local key as well.


...Skeeve

--
Skeeve Stevens, CEO/Technical Director
eintellego Pty Ltd - The Networking Specialists
skeeve at eintellego.net / www.eintellego.net
Phone: 1300 753 383, Fax: (+612) 8572 9954
Cell +61 (0)414 753 383 / skype://skeeve
www.linkedin.com/in/skeeve ; facebook.com/eintellego
--
NOC, NOC, who's there?


> -----Original Message-----
> From: ausnog-bounces at lists.ausnog.net [mailto:ausnog-
> bounces at lists.ausnog.net] On Behalf Of Greg M
> Sent: Friday, 10 September 2010 5:09 PM
> To: ausnog at ausnog.net
> Subject: [AusNOG] SSH access into 7204vxr / npe-g1
> 
> Hi All,
> 
> I am stumped on this.
> 
> We have a 7204 vxr + npe g1 at Equinix in Sydney, but nothing config
> wise I
> seem to do will grant remote telnet/ssh access over IP.
> 
> line vty 0 4
>  access-class vty-ssh in
>  privilege level 15
>  login local
>  transport input telnet ssh
> 
> access-list vty-ssh is set to permit all.
> 
> I've tried removing that, changing to telnet or ssh only - but no luck!
> 
> Currently using console cable and able to manage fine - but stuck if
> our
> management terminal goes down!
> 
> Thanks,
> 
> Greg
> 
> 
> 
> 
> 
> _______________________________________________
> AusNOG mailing list
> AusNOG at lists.ausnog.net
> http://lists.ausnog.net/mailman/listinfo/ausnog