[AusNOG] iiNet Business NBN Issues

Matt Keen | OpSys matt.keen at opsys.com.au
Tue Dec 5 14:13:01 EST 2017


Hi Jarryd,

Funny, just got off the phone with Paul McD up there!

If you "release dhcp <interface>" on the first Cisco, swap over to the other Cisco, It should get a DHCP address straight away.
Was hitting this same issue for a few customer hardware swaps, but have found doing the release, swap device, it gets an IP on first load up without waiting for 4 hours.

Matt Keen


 
Operational Systems
Telephone
0870993700
30-32 Stirling Street
Direct
0870993711
Thebarton, SA 5031
Fax
0870993799
 http://opsys.com.au
E-mail
matt.keen at opsys.com.au


-----Original Message-----
From: AusNOG [mailto:ausnog-bounces at lists.ausnog.net] On Behalf Of Jarryd Sullivan
Sent: Tuesday, 5 December 2017 12:49 PM
To: ausnog at lists.ausnog.net
Subject: [AusNOG] iiNet Business NBN Issues

G'day all,

Over the years we've done a fair few iiNet NBN installations for our customers, however over the years we've also had a number of problems. I'm wondering if anyone can shed some light on the issues we've had. Pretty much 95% of the time if we swap a router over for a customer (e.g. Cisco 867/887 to a Cisco 1921) we have no end of issues getting a DHCP lease on the new router, the usual support response we get when calling business support is to turn the NTD + Router off for 4 hours and then turn it back on and  the issue will be resolved. Early on we used to do this, and confirmed it'd work, but I can't understand why we're waiting 4 hours for a business service just by us simply putting a new router in, so I continued to push harder and harder when calling support, one day I managed to get an helpdesk staff member who was speaking to a Level 2 colleague that managed to immediately clear all active sessions for this customer and within seconds we got a DHCP lease.

Today I've got another customer again, same issue changing from an older 887 to a 1921 and the configuration is spot on, it was doing my head in until I remembered this issue. Called support, same response, "NBN limitation, wait 4 hours and it'll start working". To which I asked why this doesn't affect Telstra, Aussie Broadband and a number of other providers using IPoE. The helpdesk staff member then did a "kick user" and then an LDAP resync and then apparently he's logged a dcs clear now, to which my customer is now waiting an unknown period of time until this ticket gets sorted.

I'd appreciate any help from anyone, or any suggestions to get this working quicker, and hopefully if anyone from iiNet is on list they can address this issue that's been happening for years? Cheers

Jarryd Sullivan


________________________________

The information contained in this message and any attachments may be confidential information. If you are not the intended recipient, you must not use or forward the information contained in these documents. If you have received this message in error, please delete the email and notify the sender.

Internet communications are not secure. You should scan this message and any attachments for viruses. Under no circumstances do we accept liability for any loss or damage which may result from your receipt of this message or any attachments.
_______________________________________________
AusNOG mailing list
AusNOG at lists.ausnog.net
http://lists.ausnog.net/mailman/listinfo/ausnog



More information about the AusNOG mailing list